Wet rooms in Shenstone

Before your wet room in Shenstone

This kind of work rarely needs planning permission, but it does have to comply with Building Regulations, and some parts must be certified by a registered installer or signed off by building control. In Shenstone, building control is provided by Lichfield District Council or a registered building control approver (formerly an approved inspector).

Extract fans in a bathroom without an openable window should run on for around 15 minutes after use.
Upstairs wet rooms on timber floors usually need structural plywood and a preformed former set between the joists.
Starting work before the council approves a Disabled Facilities Grant can mean losing the grant entirely.

Postcode district: WS14
Planning and building control: Lichfield District Council
From our West Bromwich base: 10 miles

Choices to weigh up in Shenstone

Upstairs on a timber floor

The floorboards are replaced with structural plywood, and joists are checked and sometimes strengthened. A preformed tray former is set between the joists to create the fall, and the waste must run with the joists or through them within safe limits. If the route is too long, a pumped shower drain may be used.

Level-access walk-in shower

Instead of falling across the whole room, a sloped former is set flush into the floor only in the shower area, with the rest of the floor flat. It gives step-free access at a slightly lower cost. The surrounding floor and walls are still waterproofed, because water rarely stays exactly where it's meant to.

Guide prices for Shenstone

For a home in Shenstone, our guide range is £5,000–£15,000 depending on size and specification. Converting a 2 m × 2.5 m bathroom into a fully tanked wet room with a level-access floor: usually £6,800–£9,000.

Guide prices for wet rooms
Option	Guide price	Good to know
Level-access walk-in shower in an existing bathroom	£5,000 – £7,000	Former in the shower area only
Full wet room, fully tanked	£6,500 – £9,500	Suits a standard-size bathroom
Accessible or larger wet room	£9,000 – £15,000	Rails, seat, wider door, underfloor heating

Guide ranges include VAT where it applies. Your fixed price for the agreed specification follows a free survey at your Shenstone address.

Before you book in Shenstone

How long does it take to build a wet room?

Most take 8–14 working days. Floor preparation and tanking take longer than in a standard bathroom, and the membrane needs time to cure before tiling. Timber floors upstairs often need new plywood and joist work first. If it's your only bathroom, we'll plan the toilet to be usable at night for as much of the job as possible.

Do you cover Shenstone?

Yes. Shenstone (WS14) is about 10 miles from our West Bromwich base and inside the area we cover. Call 0800 088 6248 or send the form on this page to book a free survey.

Will a wet room leak into the room below?

Not if it's built properly. The risk comes from poor tanking, an incorrect fall or a badly sealed drain, not from the idea itself. We tank the whole floor and the shower walls, seal every corner and pipe entry, let the membrane cure, and flood-test the floor before handover. Most wet room problems trace back to rushed preparation, so we don't rush it.

Who approves wet rooms in Shenstone?

You won't usually need planning permission, but the work must meet Building Regulations. Building control in Shenstone is provided by Lichfield District Council or a registered building control approver, and some work is self-certified by registered installers.

Also covering nearby

Other work we do in Shenstone

Tell us who'll be using the room and how, and we'll design around that, with no obligation.